Day: April 7, 2019

Sailing from Cap d’Agde to Roda de BaraSailing from Cap d’Agde to Roda de Bara

(Featured image is a fishing vessel from Port Roses. Don’t worry, the photo was shot with a Telelens)

From France to Spain March 19, 2019rdb 1

Our departure day has arrived. The desire to finally sail again is getting fulfilled. In the prior week we had sailed from La Grande Motte to Cap d’Agde (35nm). We got our feet wet and tested the boat.

This trip is close to 190nm and leads around Cap Creus. The cape marks the border between Spain and France and has its reputation in winter time due to the frequent, ferocious Tramontana winds. Our plan was to pick a weather window behind a front with receding winds, but still enough wind to have the boat moving. Yeah- we got the boat moving.

Weather Forecast:


Early morning 6am UTC


36 hours later. Front has receded.

The wind forecast was nearly point on. The wave forecast not so much. For the gusts above 30kts we were prepared with a 2nd reef and had our small jib ready to hoist. In the end, the wind never felt as bad as the waves, especially 50 miles south of Cap d’Agde.

We began docking off early in the morning, but needed the dinghy to get our lines off the mooring buoys. First, we helped our friends on JAMS, a new Outremer 51, to do the same. Due to the very strong winds the night before, we had changed our mooring lines from slip through to just being tied with a bowline hitch to the mooring balls. Chafing was our main concern.

The first stretch we had planned to sail together with JAMS, who were heading to Port Vendres in France. It took more than an hour to get the mooring lines sorted out and the dinghy hoisted again. At 0930h we finally left port. The sun was shining brightly as we maneuvered out of Cap d’Agde. We noticed how slow our boat was moving due to the marine growth on the hull under water. This is caused by our long times staying in port. At 2000 rpm, on one engine, we had lost around 1 kts boat speed – down from 6.2 to 5.2kts.

In fresh wind (20kts+) we hoisted the main with a second reef and unfurled the genoa for a nice downwind heading. Soon both boats, Lunara and JAMS, sailed at double digit speeds.

The first two hours sailing were great, but the more we moved away from land the stronger the wind became and the longer fetch of free water allowed the waves to grow. The Admiral became crabby, she got the (sea) flue.

cda rdb-3

Waves in photos always look puny compared to reality. By this time we were sailing constantly 10kts+

Initially it was warmer and quite sunny. Never forget, it’s still winter.

Dark Forces Escape-4

Under way in the Golf du Lion. A bit later we encountered 35kts winds from behind and pretty good waves.

cda rdb-4

When my watch came up the temperature had dropped to 10°C. I am dressed for the occasion.

As we rounded Cap Creus, we had averaged 10.5kts and hit a top speed of 17 kts. The tripmeter’s 8.4kt average (picture below) requires an adjustment for the hour or more spent leaving the dock and raising the main sail. We were quite impressed, considering that the hull has a lot of drag from the marine growth.cda rdb-5

10 hours into the trip, past Cap Creus, we met some fishing vessels heading home to Port Roses.

cda rdb-11

Fishing vessel south of Port Roses. This guy came very close and ignored us completely. He was crossing us head on a collision course.  We took avoiding action.

cda rdb-9

This captain changed course early, to pass neatly behind our stern at a good distance.

Mid evening we passed a former dock neighbor from La Grande Motte ‘Orialine’ (Outremer 51). I just got a shot from very far away.

cda rdb orialine-1

Night broke, the wind receded to a tad above 20 knots. Boat speed was an easily manageable 7 kts. The Admiral was still out of commission.

cda rdb-13No worries, as we planned to stay in deep water passing Barcelona 10 miles to the south. Started charging the batteries with the generator. After 60 minutes the generator …..

cda rdb-12

Generator Control

…said adios amigo. Not really surprising, except it is the second, replacement generator and had less than 10 hours runtime. Upon arrival I inspected all the possible reasons for overheating and found some 🙁

The fuel pump was installed horizontal (should be vertical), which creates bubbles in the diesel and a lean fuel mix for the generator leading to overheating. Second, upon taking the water filter apart (yes, I checked the impeller pump first), I found an installation novelty: Sikaflex (silicone sealing) in the filter intake and output. Why? The filter was not meant for generators, had conical connections and the flat hose connectors do not fit a conus- obviously. So, a lot of Sikaflex was used to make it fit. Some people, please don’t call them marine professionals, should never have access in their life to either Duct-tape or Sikaflex. It should be a controlled substance and subject to something similar to a firearms permit!

cda rdb tech-4

Water strainer input and output looked like this!

Anyway, I ordered a proper water strainer which took 2 weeks to get here and will install it tomorrow.

Now, we run the engines to charge the batteries – yes, you guessed it right – something else happens. An Volvo engine control alarm with a piercing loud beeping signals alerts us that one of the smaller 60A alternators is charging with 15V. The electrician company later commented ‘Don’t worry, the 15V won’t reach your batteries’ Great, a) why does Volvo programmed this alarm? b) how do you sail/live with a 110dB alarm? What are my options? Not using the engine?

See ‘ALT STARBOARD R’ 15V in the picture.

cda rdb-14

Around midnight we began passing Barcelona. The town and coastline is well lit. Not much ship-traffic at this time as most ferries, cruise- and cargo ships seem to want to stay in port during night. When we had nearly passed Barcelona, at 0500h, the traffic awoke and we had to dodge a lot of the bigger guys.

The night was beautiful with clouds alternating with a full moon. Even the Admiral, in her sad state with a flu, enjoyed the view. The full moon set precisely at the time when in the east the sun was rising – magical. We sailed and motored on towards our destination Roda de Bara to arrive their early afternoon.

I was a bit exhausted, as I had been on watch most of the last 36 hours. 5 miles away from port we lowered the sails and set the autopilot on a NW course for the port entrance. We motored slowly with one engine a little above idle rpm, so that I could get an urgently needed nap for 45 minutes. I don’t like to drive into a foreign port super tired. Even a short nap works wonders (thanks Andrew for the tip!)

Upon arrival and after a messy fight with the dirty mooring lines I got our little electric scooter out on the dock and checked in at the Capitanerie. The gentlemen managing the marina is a very nice former east German navy officer. He remembered all the west German navy’s surveillance ships by name – the ones I had sailed on in the 70s. You can imagine we had a nice long check-in chat 🙂

Late next morning, after a good sleep, I inspected the boat and found some more installation defects and deficiencies. The port side main bilge pump was damaged. Someone had stepped on it most likely during the water maker repair. Two notches of the casing were broken off. The pump was sitting loose and the impeller chafed in the housing. Ordered a replacement (160 Euro!) and installed it.

cda rdb-26

Damaged Bilge Pump

Upon repair I found the pumps electrical wires had several cuts and corrosion had set in (not visible from the outside). So I replaced a longer stretch of the cable as initially planned 🙂 the joys of boat owner ship!

Port Bilge pump Nauitech Wiring. not waterproof.

Port bilge pump wiring damaged. No longer waterproof.

Then working on the generator overheating issue I discovered another installation no-no. The base plate of the throughull for the generator is mounted partially free floating and not fully painted, hence, not waterproof. Ultimately, the wood will rot and cannot support the pressure from the tightened throughull. Even today, it is a compromised installation. Will haul out in Cartagena (next port) and replace!cda rdb tech-5

Further, one disconnected electrical wire from one alternator (not the overcharging alternator) was hanging loosely in the bilge touching the water 🙁 Have to check if it’s still hot, as this wire was prior used to signal the house battery voltage to the alternator.

In the port engine room the B&G autopilot controller fell of the hull. It was improperly glued/Sikaflexed to the hull (see prior post). You can have some fun with this stuff – see picture below.


The SIKA man

Roda de Bara

is remarkably warmer than Southern France at this time of the year. Less wind and 300 days sunshine is more than good enough for us! Roda de Bara is quiet and idyllic in a positive way, but also means less restaurants being open during winter (nearly none during the week).

rdb roc-1

El Roc de Saint Gaieta

Some impressions of this very nice beach town:

rdb roc-4

This stretch of the coastline is part of the Via Augusta, built in 10BC

rdb roc-6

El Roc de Saint Gaieta

rdb roc-5

El Roc de Saint Gaieta

rdb roc-3

El Roc de Saint Gaieta

rdb roc-2

El Roc de Saint Gaieta

rdb roc-7

Vitamins! Banana Split.

cda rdb-17

Super clean water in the marina

cda rdb-20

Roda de Bara Marina

cda rdb-19

Marker on seawall

Ah yes, the food: Carnivores do not suffer in Spain. This is the Lidl supermarket with a great selection of local Iberico ham:

Dark Forces Escape-7

This was a long post, but fun to write. If you made it until here you deserve a glass of Rose!